ZoneMinder Forums

OK, now it makes more sense. Thank you. I'm now getting email successfully. However, the image tag is blank. You mention the need for

Ahhh... that was the missing item, the requirement for %EI1%, %EIM%, (or presumably %EIV%).

Where do those tags go?

Sorry for the dumb question, but I have searched everywhere and I just can't find a simple example on how to setup a filter to email me when a motion event occurs. I have Mocord setup and I'm seeing the events. I also created a simple perl script to test the email sending function and it works. The ...

Yes I did run ./configure. Do you remember what you had to link? I really don't want to blow away my system again, it took a long time just to get this far...

I'm having the same problem. I have uninstalled ffmpeg, svn the source, make, make install. All successful. ffmpeg claims to be build from SVN-r10672. Make configure is as follows ./configure \ --with-mysql=/usr \ --with-webdir=/var/www/html/zm \ --with-cgidir=/var/www/cgi-bin \ --with-ffmpeg=/usr ...

No luck. Thanks for all the help. I ended up swaping to an intel motherboard. Its working now...

OK this is the 'bad' [root@SudburyHomeMonitor dhorth]# cat /proc/interrupts CPU0 0: 222215 IO-APIC-edge timer 1: 139 IO-APIC-edge i8042 2: 0 XT-PIC-XT cascade 8: 1 IO-APIC-edge rtc 12: 4932 IO-APIC-edge i8042 14: 16880 IO-APIC-edge libata 15: 811 IO-APIC-edge libata 16: 100801 IO-APIC-fasteoi bttv0 ...

I'm not seeing the IRQ during post but I thought that the lspci info might be helpful ----This one fails! 00:08.0 Multimedia video controller: Brooktree Corporation Bt878 Video Capture (rev 11) Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap ...

All my IRQ's are set to available

You say make sure that PC1 is not sharing an IRQ with anything. How do I do that?

sorry, by no-go I mean no video. dmesg shows the card as unknown/generic. lpci sees the card, and it appears to be correct. xawtv also shows black video, plus when I change the capture mode, or the channel, I get an input/output error from v4l2. I've tried setting the card type in modprobe.conf as ...

OK I'm a bit of a newbe, but I have set up a system and if my capture card (a 4-port type 77 card) is in the first pci slot no go. If I move it to the third slot I'm ok. The reason this is an issue is I'm trying to put this system in a 2U case, so I only really have the 1st slot w/riser. My MB is an ...

found the problem, an outdated zmupdate.pl script

I'm running on Fedora 7 I'm getting the following error when I attempt to start zoneminder zoneminder failed. The error was: Stopping zoneminder: [FAILED] Bareword "ZM_PATH_DATA" not allowed while "strict subs" in use at /usr/bin/zmupdate.pl line 323. BEGIN not safe after errors--compilation aborted ...

Did you find a fix for this issue. I'm in the same boat!