ZoneMinder Forums

Thanks.I did greater than 30 day and it deleted all the events.I will have to wait 30 days and find out how
your suggestion works. Why is there "-" before the 30 day and do I have to do this for every monitor ?
thanks
Yoseph

I know this question has been asked and answered many times before.But all my searches keep taking me back to the Wiki which is a bit more reading than I like to do. How do I set up filters to delete events over 30 days old? My system load goes above 1.0 consistently when my Disk is about 15% full ...

I think I have a good UID and Password set up for my system but look all the failed attempts that some body has made to access my system. One of these days it is going to succeed. Is there a way to prevent these types of multiple attempts, like 5 attempts and your IP address is locked out or ...

The way it worked for me is that if I wanted to play the last five events I select the oldest of the five events and it plays from the oldest to the most current event. If I selected the most current event it will only play a single event. It did not skip backwards in time for gapless play. You may ...

All I have on the system is zoneminder for home surveillance but, I would still like to have
it secure. I use Putty to occasionally access the system. How do I change that to another
port other than port 22? thanks

I found these client IP addresses in my apache error log and non of these are addresses that I have used. Is a strong password enough or do I need a software to protect my system? thanks. [Fri Dec 11 01:06:18 2009] [error] [client 71.96.21.105] File does not exist: /var/www/MNG [Fri Dec 11 07:27:55 ...

I get a ton of this message in apache error log. What does it mean and how do I correct it? My system sometimes show high load and gets hosed up and locks up. I don't know if it has anything to do with this. ++++++++++++++++++++++++++ [Mon Dec 07 19:30:46 2009] [error] [client 192.168.0.105] socket ...

Yes I did. I followed the procedure strictly.
thanks

I tried to use this http://www.zoneminder.com/forums/viewtopic.php?t=14783 and installed ffmpeg but make exited with an Error. It is a fresh install on to ubuntu 9.10 server 32 bit and here are some of the warnings and error. I hope some one can help. Thanks much ...

I installed Zoneminder on ubuntu 9.10 server 32 bit. I used the installation procedure for ubuntu 9.04 in the Wiki. "apt-get install sysvconfig" appeared earlier in the procedure before I installed zm but I got a response that said "sysvinit-utils replaces it" and "E: Package sysvconfig has no ...

Thanks Sidon. "# include <stdio>" worked. It compiled without errors after that.
Thanks much for your help.

Here are a few of the lines from make. I couldn't cut and paste from a server terminal on another computer. ================================ : : zm_utitls.cpp:32: error: 'vsprintf" was not declared in this scope : : zm_utils.cpp:47: error: "vsprintf" was not declared in this scope : : : make[2 ...

I followed the ZM installation guide on Ubuntu 9.04 server 32 bit. But the compilation failed and "make" returned 2 errors in the "Install & Config zoneminder" section. If you had a successful zm install on Ubuntu 9.10 server 32 bit please help with how you were able to get it done. If you followed ...

I am not going to pretend to know much but I would look in to the memory
requirement because 512mb seems to low. See if you can run only one
camera and see the picture improve.

Try modect, that worked for me. I selected the "best low sensitivity" in
the zone.