ZoneMinder Forums

Thanks for your reply... strange occurence... For some reason my camera is not able to boot or capture an IP address after I successfully was able to get ZNM to see my camera. I was able to bring up the picture but when I shutdown and went to restart ZM, the camera was not recognized and does not ...

My settings match (320 x 240) and I was able to see the camera on ZM. It's set on Modect and the only problem is that the actual video seems to have a long delay before it shows up on the monitor. Since I don't have a PTZ camera, will the code mentioend above help improve the frame rate? In other ...

I still need to know if the Remote Host Path is valid. I do not see this file in any of my folders. Do I need to apt-get anything before I run ZM?

I am trying to setup a Foscam FI8904W through ZM. The camera is operational via the software that came with the camera. The problem is that when I load ZM with the following, I get the IP address in red. I have also tried to hook it up directly with ethernet and the same results. General Name - Cam1 ...

OK - Strike 2 for me. I setup the camera direct to ethernet and same thing. I also used the generic setup you suggested and I still get the red IP address showing on the ZM console. The only thing I can think of is that my remote path name is wrong; Remote Host Name: username:pwd@x.x.x.x (is this ...

It worked for one minute (IP address was green) and the video was black. I am new to Linux so please bear with me. Do I need to configure anything in using the videostream.cgi file? also.. Did you make your camera static? If so, how did you do that? I am running DHCP and see that the IP addy keeps ...

Hi, I am trying ot get ZM to see my Foscam FI8904W camera . The IP address shows up in red which I know means there's no connectivity. I know the camera works because I was able to use the software it came with on an Windows XP environment. I have looked at many posts and there isn't a step by step ...