ZoneMinder Forums

Testing indicates that Selinux in enforcing mode still is causing some issue's on Fedora 19 for tthese issue to be resolved a bug report to redhat bugzilla is required so that the selinux denial can be resolved otherwise is stays in the package for other users to get caught up on. For other issues ...

Sounds interesting but I agree that it needs community involvement to truly move forward and get some of the problems solved that make it hard to setup, compile, configure and package for distributions, and helps spread the load and ideas to come up with the best solutions. Unfortunately their are ...

Do a search on this forum as it has come up before, I am fairly sure that it is also mentioned on the Redhat Bugzilla site with references back to other sources, hope this helps.http://www.zoneminder.com/forums/postin ... f4559e821d#

Great work on the performance improvements, testing on 1.26 so far indicates the figures obtained are a positive step forward. :) It would be great to be able to limit the capture size to a particular size and then scale to whatever in the monitor. Lots of work, but overheads may not be wothwhile,or ...

I agree on raid array or sas but it is not going to be cheap.

I tested Zoneminder several years ago with a 4 port separate bt878 chip per port card at maximum frames 20-30 frames/second on a dedicated dual pentium 3 server board with was loaded with only the O/S and Zoneminder. The loads where always over 1.0 and at times 2.5 to 3.5 top indicated that ...

I tested Zoneminder several years ago with a 4 port separate bt878 chip per port card at maximum frames 20-30 frames/second on a dedicated dual pentium 3 server board with was loaded with only the O/S and Zoneminder. The loads where always over 1.0 and at times 2.5 to 3.5 top indicated that ...

Looks like an irq problem on the bus. From the messages as per below and the others. Try moving the card to the first slot available then boot up and see how it goes. check for options on bios for the slots the capture card is fitted too. I have seen a pci capture card stop a motherborad dead not ...

For anybody using fedora 17, 18 and 19 and trying version 1.26 please search the Redhat bugzilla for Zoneminder problems that exist for the 1.25 version at least you shall be fore-warned. Selinux policy has been updated several times with fixes for most of the problems in Version 1.25 and some which ...

On fedora 19 32 bit the source will compile without ffmpeg just fine, need several changes to configuration to get it to display in a brower. Tried several ffmpeg sources so fair with good and bad results. When I have some more time shall post a configuration that will ease the problems with a ...

Zoneminder service file has been broken for several releases.

You may want to try the Redhat Bugzilla for some info

Search for zoneminder, Some info here to help.