ZoneMinder Forums

That's fantastic! I'll download it and check it out.

I can put mrd's 4N scripts where I have my older 2N scripts - I've edited the post to point to my 2N script's new location...see the beginning of this thread, about 4 posts down. It the 1.22.3 version. Post if that link isn't working. And be careful you don't try the first post - it's for the older ...

I don't think so...

The original server is offline, but I'll get something up and on that link with the files later today...

Two things: 1) I've written the first half of the PTZ2N control script, which works for PTZ - I've still got to code up the Focus, Iris, etc... 2) I haven't installed the newest version of ZM, so I'm not yet familiar with any changes made to the control script setup. If there's adapting to do, I'll ...

I know I had some specifics from an old V2 doc. I just haven't found it yet. Maybe post a picture of it to the Wiki? Worst case I can eavesdrop on another program that *can* control it.

Probably either a different serial pinout, different initialization sequence, or different hardware I/O (RS422). I'll know in another few minutes of Googling and scanning the archive of the previous incarnation of this machine. Before this machine died/was reborn, I had an archive of all the PolyCom ...

Gimme a minute to scare up the PictureTel V2/V3 control command set and have a look...they enhanced the V1 command set (PTZ1/PTZ2 series cameras) for the subsequent cameras...

Is it serial or RS422?

-g

Absolutely! Just send me a PTZ4N.

Ok, I finally got to the Sony SNC-M3W patches, control script, and Wiki page.

I'll use the Wiki page for a template for the PTZ Wiki entry sometime this week...

Or...you could download Version 3 which contains identical patch files and the latest [fully functional] control script.

The script is also available by itself.

And who knows...theWiki page section about setting up the control may even magically fill itself in...

Here are the newest patch files for the SNC-M3W and SNC-M1W in a gzipped tar file containing two patches [tested/working] and the latest [buggy] control script. This'll get to the Wiki shortly, with a revised control script and setup instructions. Basically: Open a shell. Go to the ZM sources ...

So, I've posted the newest patch files for the SNC-M3W and SNC-M1W here as a gzipped tar file containing two patches [tested/working] and the latest [buggy] control script. I'll start a new thread that explains patching and recompiling, and then update the Wiki page with the same info. Basically ...

A quick apology to all - I'll have the 1.22.3 patches done by the weekend. Thought they were done, but in the process of reloading that machine I seem to have lost them...

I think I discovered that the SNC cameras are supported under 1.22.3.

I'll check that today and post the patches if not...

Maybe even get the camera control script finished? Sorry - been working a lot lately and no free time to hack...