Is there somebody that use ZM with PCI Grandtec XGuard 4P ? If there is one I have some question:
- does it works fine this card?
- someone tell me that on Linux this card play fine, but only with 1 port, NOT 4 like in Windows... it's true???? I hope no....
I bought this card in order to have 4 port...not only one...
Another question:
- is there anyone that use ZM with Slackware 10.2? it works fine ?
hi.
I have this card and its loaded as card=104. It works fineon all ports, one camera 30fps, two cameras 15 fps, 3=7fps, 4=3,5-5 fps. 924 x 576 (if your camer supports it.)
dmesg.
Linux video capture interface: v1.00
bttv: driver version 0.9.15 loaded
bttv: using 8 buffers with 2080k (520 pages) each for capture
bttv: Bt8xx card found (0).
ACPI: PCI Interrupt Link [LNKA] enabled at IRQ 16
ACPI: PCI interrupt 0000:01:06.0[A] -> GSI 16 (level, high) -> IRQ 201
bttv0: Bt878 (rev 17) at 0000:01:06.0, irq: 201, latency: 64, mmio: 0xeba00000
bttv0: detected: Grandtec Grand X-Guard [card=103], PCI subsystem ID is 0304:0102
bttv0: using: Grand X-Guard / Trust 814PCI [card=103,autodetected]
bttv0: gpio: en=00000000, out=00000000 in=00ffffff [init]
bttv0: using tuner=4
bttv0: i2c: checking for TDA9887 @ 0x86... not found
bttv0: registered device video0
bttv0: registered device vbi0
bttv0: PLL: 28636363 => 35468950 .. ok
bt878: AUDIO driver version 0.0.0 loaded
bt878: Bt878 AUDIO function found (0).
ACPI: PCI interrupt 0000:01:06.1[A] -> GSI 16 (level, high) -> IRQ 201
bt878(0): Bt878 (rev 17) at 01:06.1, irq: 201, latency: 64, memory: 0xebb00000
btaudio: driver version 0.7 loaded [digital+analog]
