Added IP Camera - only black image

[tstier0809]

These are all settings - mostly derived from my other camera which works fine.

Monitor - IR
Name IR
Function Record
Section length 300
Frame Skip 0
Run Mode Continuous
Triggers None available
Source Type Remote

Remote Host Name: admin:PASSWORD@10.0.0.8
Remote Host Port 80
Remote Host Path /cgi-bin/video.jpg
Remote Image Colours 24-bitcolour
Capture Width (pixels) 352
Capture Height (pixels) 288
Orientation Normal

Image Buffer Size (frames) 10
Warmup Frames 25
Pre Event Image Buffer 10
Post Event Image Buffer 10
Alarm Frame Count 1

Event Prefix Parkplatz
Maximum FPS 10.00
FPS Report Interval 1000
Reference Image Blend %ge 10

Thanks a lot for your support!

[jameswilson]

im assumin gthen that you have the settings identical for both cameras. If i were doing this id remove the authentication from the camera just to ge it working in case there is an issue here somewhere.

The other thing you could try is set your working monitor to your new ip, and if that works you know its a setting issue in the other monitor, if it doesnt then its ompletly soething else