Axis 2100 v2.02 and Zoneminder with Password

drock2006 · Post by **drock2006** » Fri Mar 10, 2006 9:16 pm

I am trying to get a AXIS 2100 network camera working with zoneminder. I have non-networked cameras working fine with zoneminder, so I am going to go out on a bridge and say my installation and configuration is working fine. Don't stone me too bad.

The IP address of the network camera is 10.10.10.1.
I am using the following configuration as a Monitor.

Source Type = Remote
Function = Monitor
Enabled = Check
Max FPS = 0
Reference Blend = 7

Source
-----------
Remote Host = Http://10.10.10.1
Port = 80
Path = /cgi-bin/hugesize.jpg?motion=0 (Not sure this is right)
Colours = 8-bit gray
width = 320
height = 240

FYI. There is a password required to view it from it native web site. I don't know how to tell zoneminder to use a username and password or how to remove the password all together from the AXIS 2100.

With the above configuration I just get a red Http://10.10.10.1 under the Source on the main page.

Thanks in Advance and Yes I have it working under SLACKWARE. SLACKWARE Rocks@@@

jameswilson · Post by **jameswilson** » Fri Mar 10, 2006 10:39 pm

i dont know about the path, but to pass user name etc use

user:password@ip

axis cams are great apart from a post i read on here re a mem leak on a 207

drock2006 · Post by **drock2006** » Sat Mar 11, 2006 12:43 am

Ok understand how. But where does this information go as it relates to zoneminder.

i.e Remote Host, Remote Path, etc

jameswilson · Post by **jameswilson** » Sat Mar 11, 2006 2:32 am

in the host with the ip!
To be honest while your learnign and playing id disable all the security and add that at the end once you know all is good!