Capture Problem: 1.22.2 vs 1.21.3 with Axis 2100 Cams

Axel · Post by **Axel** » Fri Sep 01, 2006 8:42 am

Yes, indeed. The cam stucks. This is the first time. Maybe because i use MPEG now? After restart the cam, the problem with zoneminder is the same.

You can access now the 207, use the same link i sent but port 92, please.

jameswilson · Post by **jameswilson** » Fri Sep 01, 2006 5:45 pm

so to clarify how do you get this working again
do you
a) restart the camera
b) restart zm

Axel · Post by **Axel** » Mon Sep 11, 2006 8:13 am

Hello again.

Yes. Today i restart cam and entire system.

Now it works a while before the cam will be hang.

Maybe its the cam/release 4.22?

Anyone have a newer? Beta?

Greetings,
Axel

Axel · Post by **Axel** » Mon Sep 11, 2006 9:41 am

Incredible!

TODAY morning, i talk to the support - Line and they suggest changeless, no newer firmware or bata is available.

30 minutes later, i receive a link from axis, with the new release 4.40.

Hooray! Now i try it first.

Will post the result after try out.

Greetings,
Axel

Post by **zoneminder** » Mon Sep 11, 2006 2:09 pm

Good, is this firmware for the 207 only? Let us know how you get on.

Axel · Post by **Axel** » Thu Sep 14, 2006 5:48 am

Hi Folks.

After updating the 207 with 4.40, the cam works without any problems since 4 Days.

Now i try to replace two of the 2100 by 207, because the problems with the 2100 and 1.22.2 will continue.

Because i cannot longer operate 2 systems, i must switch of the older system this week.

Two other 2100 on the 1.22.2 exist and i would be gratefull for any hints.

Thanks to the community for all the help,

Axel

anachrnism · Post by **anachrnism** » Wed Apr 04, 2007 7:54 pm

I know this is an old post, however I came across a similar problem with my install, and stumbled across this thread.

I eventually found my problem. I had my 207's and the server set to auto-negotaite speed and duplex. I had everything hooked up to a netgear hub (so half duplex), and saw a _lot_ of zmc restarts from my 8 cameras. I think their could have been problems when devices re-negotiated. Swapping the hub for a switch (full duplex goodness), and my problems went away.

Might work with the hub if everything is set to half duplex, no auto-neg, but was quicker to use the switch than change each camera.

Post by **zoneminder** » Sat Apr 07, 2007 7:33 pm

Thanks for posting this, I would never have thought of that. I thought everything was full duplex nowadays