is possible to limit the duration of the events?

sendark · Post by **sendark** » Mon Aug 06, 2007 2:16 pm

hello, my question is that i have a camera looking at a place i which people is moving all the time, and i want to limit the duration of the events... because all the events that i can get are very big, and is beeter for me if something happen, locate the correct event.

Any help please (i tried to search on the forum, but nothing appears) and also the wiki.....

THANKS A LOT

Lee Sharp · Post by **Lee Sharp** » Mon Aug 06, 2007 4:31 pm

If it did, that would just cause the movement to trigger another event. It would be better to spend some time working on the triggers so that unimportant movement is not a problem. Read the section on configuring zones a few times. It took more than one read for me...

sendark · Post by **sendark** » Tue Aug 07, 2007 8:06 am

so. is not possible? my idea is create a new event every 5 minutes.....

darkpaw · Post by **darkpaw** » Tue Aug 07, 2007 12:53 pm

If there is motion there all the time, then why even both using motion detection? Just put it in record mode and have it run all the time. You can configure the length of the video with the "Section Length" option under the "Misc" tab in the configuration.

Try that...

sendark · Post by **sendark** » Wed Aug 08, 2007 11:15 am

but this is not working, i only can get a big big event......

Lee Sharp · Post by **Lee Sharp** » Wed Aug 08, 2007 9:07 pm

By default, you get a 10 minute event. How long does the motion last?