xawtv and channels on bt878

[yavan]

ok i have changed modprobe.conf for this settings:
linux-102:/home/user # dmesg | grep bttv
bttv: driver version 0.9.16 loaded
bttv: using 8 buffers with 2080k (520 pages) each for capture
bttv: Bt8xx card found (0).
bttv0: Bt878 (rev 17) at 0000:00:0a.0, irq: 5, latency: 32, mmio: 0xe9101000
bttv0: detected: Provideo PV143A [card=105], PCI subsystem ID is aa00:1430
bttv0: using: GrandTec Multi Capture Card (Bt878) [card=77,insmod option]
bttv0: gpio: en=00000000, out=00000000 in=00ffffff [init]
bttv0: using tuner=-1
bttv0: i2c: checking for TDA9875 @ 0xb0... not found
bttv0: i2c: checking for TDA7432 @ 0x8a... not found
bttv0: i2c: checking for TDA9887 @ 0x86... not found
bttv0: registered device video0
bttv0: registered device vbi0
bttv0: PLL: 28636363 => 35468950 .. ok

but i am still getting the same bad B/W stream picture

[muzyk10]

then i would add "gbuffers=16" option and check also for debugging messages from logs (activate ZM_EXTRA_DEBUG, set ZM_EXTRA_DEBUG_LEVEL to reasonable level). I had this weird lines as U has now but really dont remember what it was about .

[cordel]

Check the documentation with xlibshm and or xlibshm --help
There are two options for a monitors palette, I suspect you just chose the wrong one.