The emerge part went ok and then ran the zmupdate.pl (see below) which went ok after I got the right version and username/password. I also ran zmupdate.pl -f. ZM starts and I can see images from the three cameras but I have a few problems one minor and two major.
1. when I logon to ZM it still show the version as 1.22.3
2. the number of events now totals hour+day+week+month AND + archived. I can't remember it doing this before.
3. When I look at an event from one of the cameras and the select the next button it shows me an event from one of the other two cameras. But if I select a each event from the list for the camera it is the correct event.
I have also run a mysqlcheck (see below)
zmupdate.pl -v 1.22.3 -u root -p
Warning, overriding installed ./zm.conf file with local copy
Update agent starting at 08/04/28 16:11:37
Initiating database upgrade to version 1.22.3
Please ensure that ZoneMinder is stopped on your system prior to upgrading the database.
Press enter to continue or ctrl-C to stop :
Do you wish to take a backup of your database prior to upgrading?
This may result in a large file if you have a lot of events.
Press 'y' for a backup or 'n' to continue : y
Creating backup to zm-1.22.3.dump. This may take several minutes.
Database successfully backed up to zm-1.22.3.dump, proceeding to upgrade.
Upgrading database to version 1.22.3
Loading config from DB
Saving config to DB
Database successfully upgraded from version 1.22.3.
Database successfully upgraded from version 1.23.0.
Database upgrade to version 1.22.3 successful.
Update agent exiting at 08/04/28 16:11:51
mysqlcheck --all-databases --auto-repair -pzmpass -u zmuser
zm.Config OK
zm.ControlPresets OK
zm.Controls OK
zm.Devices OK
zm.Events OK
zm.Filters OK
zm.Frames OK
zm.Groups OK
zm.MonitorPresets OK
zm.Monitors OK
zm.States OK
zm.Stats OK
zm.TriggersX10 OK
zm.Users OK
zm.ZonePresets OK
zm.Zones OK
