Keep recording event after movement finishes?

lister · Post by **lister** » Wed Aug 13, 2008 2:35 pm

I'm sure I read somewhere that it was possible to set the length of time that zoneminder continues to record an event after all movement has finished. I've been through the entire set of config screens and can't see anything.

At the moment I'm getting lots of individual events for what is actually only one event (ie event 1 = car pulling into drive, event 2 = person opens car door, event 3 = person gets out etc etc)

Thanks

lister · Post by **lister** » Wed Aug 13, 2008 2:41 pm

D'oh! I found it seconds after posting.

(Buffers tab on device setup)