problem with defining zones??

angelhod · Post by **angelhod** » Thu Oct 16, 2008 7:23 am

hi
i cant define zones... or when i do it it doesnt work...

i define zone, i.e. the zone area is the door area...
zone is set to active plus preset is set to best, high sensivity
or fast, high sensivity
and when i go there and stand in that zone i dont get any alarm frames???

is my method correct? what do i do wrong?

Post by **cordel** » Thu Oct 16, 2008 9:48 am

Have you restarted the zm process after changing the zones?

angelhod · Post by **angelhod** » Thu Oct 16, 2008 10:17 am

well i've just did it...... but still no alarm frames

Post by **cordel** » Thu Oct 16, 2008 11:40 am

Well depending on your image size, you might have to bring some of your settings down. Like filter pixels and min alarm.
Look in the wiki on how to tune your zones.

angelhod · Post by **angelhod** » Thu Oct 16, 2008 6:23 pm

hmm but i think that the problem is not in the tuning the zone....
coz i.e. when its dark and i tunr the light on or off sa whole image changes there are still no alarmed imeges.....

ehh checked wiki... still no clue....