Hi,
I've had an anykeeper card and software running for a few years, and have tried moving over to Zoneminder a few times without success.
Until today
I've finally managed to get it working so thought I'd register and post incase it can help someone else.
I'm running Ubuntu 9 with all updates and manually installed zoneminder 1.24.2 from source.
I have the following line in /etc/modprobe.d/bttv.conf
options bttv card=131,131,131,131,131,131,131,131
I have 8x131 as I have 2 cards which I think is a WDT 2116. which gives me 16 inputs.
In order to setup my monitors I have the first one on the device /dev/video0 with the channel as 0. The 2nd monitor I've setup as /dev/video1 with the channel as 1.
I did set both on the device /dev/video0 (channels 0 & 1 respectively) but this slowed but the fps and I only use 7 inputs so seemed better to have each set on it's own device.
As for the other settings I have V4L2, PAL & BGR24 (NOT RGB). the width and height seemed to go up quite high but I set to 352 x 288. The machine handles it better and going larger didn't seem to improve quality.
The only other thing in the main options under config I un ticked STRICT_VIDEO_CONFIG.
Hope this helps someone, I'd be happy to give more info if needed. I know it's very early days but I'm so chuffed that this card finally works for me.
