(edit: I just realized I posted this in the 1.24.x forum, sorry)
Using 1.23.3. I installed my 7th ip cam in to a system that is working fine. The new cam has a very nice image and is set to modect. It is set with the exact same params as the other six cams. They are all D-Link DCS-900's and this is a DCS-910. For reasons I don't understand, each time this cam captures an event it is shown as below... This exact same line shows for each event. Help!
1274241 New Event 12/18 15:10:41 0.00 / 0/0
1274237 New Event 12/18 15:08:11 0.00 / 0/0
1274231 New Event 12/18 15:07:14 0.00 / 0/0
1274230 New Event 12/18 15:04:32 0.00 / 0/0
This is in the logs...
12/18/09 14:46:36.256127 zmdc[2141].INF [Starting pending process, zma -m 13]
12/18/09 14:46:36.271782 zmdc[2141].INF ['zma -m 13' starting at 09/12/18 14:46:36, pid = 2371]
12/18/09 14:49:43.539564 zmdc[2141].ERR ['zma -m 13' exited abnormally, exit status 6]
12/18/09 14:49:43.540322 zmdc[2141].INF [Starting pending process, zma -m 13]
12/18/09 14:49:43.546269 zmdc[2141].INF ['zma -m 13' starting at 09/12/18 14:49:43, pid = 2463]
12/18/09 14:52:22.693818 zmdc[2141].ERR ['zma -m 13' exited abnormally, exit status 6]
12/18/09 14:52:22.694284 zmdc[2141].INF [Starting pending process, zma -m 13]
12/18/09 14:52:22.701662 zmdc[2141].INF ['zma -m 13' starting at 09/12/18 14:52:22, pid = 2530]
12/18/09 14:52:32.908101 zmdc[2141].ERR ['zma -m 13' exited abnormally, exit status 6]
12/18/09 14:52:37.020802 zmdc[2141].INF [Starting pending process, zma -m 13]
12/18/09 14:52:37.025305 zmdc[2141].INF ['zma -m 13' starting at 09/12/18 14:52:37, pid = 2533]
12/18/09 14:53:00.442270 zmdc[2141].ERR ['zma -m 13' exited abnormally, exit status 6]
