1.24.2 Alarm events not ending

jameswilson · Post by **jameswilson** » Mon Mar 01, 2010 11:27 am

the presets are just that. You will need to tune them for your view. If the monitor is contantly in alarm it wont end until the alarm ends.

is your box public?

trasherdk · Post by **trasherdk** » Mon Mar 01, 2010 11:48 am

Well, it's not constantly in alarm state. Alarms trigger OK,
but just never live alarm state, thus filling my disk with
hours of images with nothing happening.

trasherdk · Post by **trasherdk** » Mon Mar 01, 2010 11:56 am

Oh sorry.

No, it's not public, but i can set up a temporary password,
if you give me and e-mail i can send it to.

mine is: trasherdk@fumlersoft.dk

jameswilson · Post by **jameswilson** » Mon Mar 01, 2010 4:56 pm

ok i have had a look.
But events are ending? You have a few events.

What else have you altered on this other than sensitivity?

trasherdk · Post by **trasherdk** » Mon Mar 01, 2010 7:14 pm

Thanks.

Nothing changed, other than change from "Best - High sensitivity"
to "Best - Medium sensitivity".

Well, events end because i SIGHUP the zma process, when i see
that nothing is going on that should cause an event.

Anyway, i'll leave it alone for a while, to see if these new settings make
a difference.

jameswilson · Post by **jameswilson** » Mon Mar 01, 2010 9:37 pm

i could do wwith seeing it when it occurs. When i looked high sens should of been fine.