Motion Detect - Alarm doesn't end

StinkyStank · Post by **StinkyStank** » Mon Mar 08, 2010 10:57 pm

When using ZM in modetect mode, my alarms don't end. I triggered an alarm about five minutes ago and my ZM is still dumping images into an event folder.

How do I fine tune this such that ZM stops capturing after X number of seconds have passed since the last detected motion?

jameswilson · Post by **jameswilson** » Thu Mar 11, 2010 2:15 pm

id expect you have the monitor too sensitive. It will still thkink its in alarm

bb99 · Post by **bb99** » Fri Mar 12, 2010 12:18 am

Are your monitors linked? If so you could be in a never ending alarm loop described in the documentation. Unlink the monitors and see if that helps.