Hy
I'm searching for a IP-Cam for outdoor (mount on wall) that is compatible to zoneminder and also payable.
I found the PC140 from Sony @ camsecure, is this one compatible or do you have any suggestion in the price range till 150EUR.
My lady preferes the DOME cams but I cannot find any with IP66, zoneminder compatible & payable beside the SK-720C-IP... but it`s 200 EUR...
requierement:
- picture of course not to bad
- low power consumption or sleep mode if no motion
- IP-RJ45
- outdoor
- view range is just 2-10m
decision guide for IP66 IP VIVOTEK IP7330
-
- Posts: 48
- Joined: Thu Jun 03, 2010 6:43 am
decision guide for IP66 IP VIVOTEK IP7330
Last edited by Schuhkasten on Thu Jun 03, 2010 9:20 am, edited 1 time in total.
-
- Posts: 48
- Joined: Thu Jun 03, 2010 6:43 am
-
- Posts: 46
- Joined: Wed Mar 18, 2009 8:38 am
Vivotek IP7330
You probably figured this out by now, but for others:
My Vivotek ip7330 is working fine with zoneminder. Its a nice little camera, although don't expect much for night vision sensitivity/noise.
The zoneminder setup is:
General:
Source Type: Remote
Source:
Remote Protocol: RTSP
Remote Method: RTP/RTSP
Remote Host Name: your.ip.addr.es
Remote Host Port: 554
Remote Host Path: /live.sdp
Capture Width (pixels): 640
Capture Height (pixels): 480
On the camera side it all camera defaults:
Authentication: disable (its on my LAN)
Access name for stream 1: live.sdp
RTSP port: 554
etc
I'm just running at 2fps, as this is enough for normal motion detection. No need to see someone winking at the camera
My Vivotek ip7330 is working fine with zoneminder. Its a nice little camera, although don't expect much for night vision sensitivity/noise.
The zoneminder setup is:
General:
Source Type: Remote
Source:
Remote Protocol: RTSP
Remote Method: RTP/RTSP
Remote Host Name: your.ip.addr.es
Remote Host Port: 554
Remote Host Path: /live.sdp
Capture Width (pixels): 640
Capture Height (pixels): 480
On the camera side it all camera defaults:
Authentication: disable (its on my LAN)
Access name for stream 1: live.sdp
RTSP port: 554
etc
I'm just running at 2fps, as this is enough for normal motion detection. No need to see someone winking at the camera