fc3 +x10 trigerring

alexl · Post by **alexl** » Thu Mar 17, 2005 11:06 pm

Hi, Cory,
can you please explain how to make x-10 trigerring
to work with your FC3 software?
Alex

Post by **cordel** » Fri Mar 18, 2005 12:13 am

Unfortunatly I do not have any X10 equipment and there fore have not had the oppertunity to play with that feature. Hopefully some one here on the forum can better advise you on how that feature works.
Cheers,
Cordel

alexl · Post by **alexl** » Fri Mar 18, 2005 3:35 pm

Cory,
is x10 support included in a FC3 I got?
Alex

Post by **zoneminder** » Fri Mar 18, 2005 4:45 pm

You should be able to just set ZM_OPT_X10 in the options and then fill in the detail in the relevent options and monitor tabs (which are hidden if X10 is switched off). The README explains what all the setting mean.

Phil

alexl · Post by **alexl** » Fri Mar 18, 2005 6:36 pm

Can't find tab "triggers" anywhere, though I
made x10 active in options.
Alex

Post by **zoneminder** » Fri Mar 18, 2005 7:25 pm

I don't think there is a Triggers tab, but there should be an X10 tab in the Monitors config dialog.

Phil

alexl · Post by **alexl** » Sun Mar 20, 2005 1:29 am

Ok,
found X10 related dialog!
There are 3 lines:
x10 activation string
x10 input alarm string
x10 output alarm string
So, what do I put in there?
Or this is in a read me?
Best regards, Alex

Post by **zoneminder** » Sun Mar 20, 2005 7:31 pm

Yes, it's explained in the README.

Phil