Panasonic Camera BL-C10

felixchu · Post by **felixchu** » Sun Apr 24, 2005 10:53 am

hi,

I would like to ask how to add Panasonic BL-C10 to ZoneMinder.

Assume the ip addr of cam is 192.168.1.100
Login: administrator
Password: abc123

What should I fill for the following fields in "Source" ?
Remote Host Name
Remote Host Port
Remote Host Path

Post by **cordel** » Sun Apr 24, 2005 8:23 pm

Remote Host Name: 192.168.1.100
The port is more than likely 80
Remote Host Path (dependeing on your install)
/cgi-bin/zms?mode=jpeg&monitor=2&scale=100&maxfps=1&user=administrator&pass=abc123
or
/cgi-bin/zm/zms?mode=jpeg&monitor=2&scale=100&maxfps=1&user=administrator&pass=abc123

Of course you may wish to set the FPS higher as The above example is set to 1.
Cheers,
Cordel

felixchu · Post by **felixchu** » Mon Apr 25, 2005 4:38 am

hi

BL-C10 itself is an IP network camera. There is no /cgi-bin/zms program inside the cam.

i think the "path" should be program path of the panasonic cam.

pls correct me if i am wrong. thanks.

Post by **zoneminder** » Mon Apr 25, 2005 2:02 pm

I have a KS-HCM10 and the path is /nphMotionJpeg?Resolution=320x240&Quality=Standard so I would think something similar would probably work with your cam. The hostname should probably be administrator:abc123@192.168.100

Phil

felixchu · Post by **felixchu** » Wed Apr 27, 2005 12:26 pm

thanks a lot "zonemider", I can add my BL-C10 cam to ZM now. Actually BL-C10 uses same program as KS-HCM10, so most of the paths are same.

By the way, I have another problem on "control". I used zmcontrol-kx-hcm10.pl for my cam, pls advise on the following fields under "control"

Control Type : I chosen KX-HCM10
Control Device: I leave it blank
Control Address: I typed "administrator:abc123@192.168.1.100"

But it cannot control movement of cam.

I tried http://192.168.1.100/nphControlCamera?D ... n=PanRight
which can control the cam to right successfully. That means the control command of KX-HCM10 should be same as BL-C10.

Post by **zoneminder** » Wed Apr 27, 2005 10:59 pm

Do you get any errors in the zmcontrol-kxhcm10.log file?

Also you have entered a username and password in the address in ZM but in your command line examples you are not including it. It would appear that the user details may not be required in the control address if that is the case.

Phil

felixchu · Post by **felixchu** » Thu Apr 28, 2005 10:07 am

Thanks a lot
i have solved the problem because missed a perl module shown from Apache log, but not ZM log.