"hiccup" in event

[pyrodex]

When my camera is triggering an event I am seeing a weird hiccup that makes the video reverse back 3-4 seconds and then restart again like normal. This is in the image frames and even in the video being generated. I can't figure out what this is happening but need someone to help me look at the settings to see if that is the issue.

I am running the following ZM version:

Code: Select all

rcrews@beast:~$ dpkg -l | grep zoneminder
ii  zoneminder                            1.26.5-1ubuntu3                                    amd64        Linux video camera security and surveillance solution
rcrews@beast:~$ 

I have the following settings for the monitoring:

Can't upload images due to a new user...

Here is a sample video showing the issue:

Can't have video link due to new user...

I appreciate any help or ideas on the situation.

[PacoLM]

Hi,

This happened at least twice when I ran apt-get update/upgrade in my ZM server and some libraries (mainly for graphics) are being updated.

I would do:
- Stop Zoneminder service
- run apt-get update && apt-get update
- Review the buffer settings, post yours here
- Restart the ZM box
- Check the behavior, should be fixed

If not, you could update your system to the ZM1.27 version.

Hope it helps,

PacoLM

[pyrodex]

I've rebooted the box many times and this is a fresh ubuntu 14.04 LTS install and fresh ZM install. Here are my buffer settings:

Image Buffer Size - 75
Warmup Frame - 25
Pre Count - 75
Post Count - 75
Stream buffer - 1000
Alarm Count - 9

I am trying to get a good few seconds of video/images before the alarm captured and ideally 2-3 seconds would be nice. Currently my Vivotek IP8332 records around 28FPS.