ZoneMinder Forums

mastertheknife wrote:Same card as mine.

What options do you use in bttv.conf?

Exactly as stated in the docs….

mastertheknife wrote:Same card as mine.

What options do you use in bttv.conf?

options i2c-algo-bit bit_test=1
options bttv gbuffers=16 card=102,102,102,102,102,102,102,102 radio=0,0,0,0,0,0,0,0 tuner=4,4,4,4,4,4,4,4 chroma_agc=1 combfilter=2 full_luma_range=1 coring=1 autoload=0

Try just with this,

bttv card=77,77,77,77,77,77,77,77

I use that with my card, and is the same as yours

DREMA wrote:Try just with this,

bttv card=77,77,77,77,77,77,77,77

I use that with my card, and is the same as yours

OK and relaod bbtv.conf ?
what should I use to reload ?

OK
I get this now…

root@CCTV:/etc/modprobe.d# xawtv -hwscan
xdpyinfo: unable to open display "".
This is xawtv-3.95.dfsg.1, running on Linux/i686 (2.6.32-5-686)
Error: Can't open display:

The 102 settings you used were correct.

I think the card might be defective or its connection to the system might be bad (because of the bus errors).
Try taking out the card, cleaning the PCI pins and PCI slot or try it in a different PCI slot.

mastertheknife.

mastertheknife wrote:The 102 settings you used were correct.

I think the card might be defective or its connection to the system might be bad (because of the bus errors).
Try taking out the card, cleaning the PCI pins and PCI slot or try it in a different PCI slot.

mastertheknife.

OK Thanks.
I thought it must be.

Also don't forget to attach heatsinks to the chips, or your card will fail pretty soon.

DREMA wrote:Also don't forget to attach heatsinks to the chips, or your card will fail pretty soon.

Where di Get those from ...?