ZoneMinder Forums

Yes, indeed. The cam stucks. This is the first time. Maybe because i use MPEG now? After restart the cam, the problem with zoneminder is the same.

You can access now the 207, use the same link i sent but port 92, please.

so to clarify how do you get this working again
do you
a) restart the camera
b) restart zm

Hello again.

Yes. Today i restart cam and entire system.

Now it works a while before the cam will be hang.

Maybe its the cam/release 4.22?

Anyone have a newer? Beta?

Greetings,
Axel

Incredible!

TODAY morning, i talk to the support - Line and they suggest changeless, no newer firmware or bata is available.

30 minutes later, i receive a link from axis, with the new release 4.40.

Hooray! Now i try it first.

Will post the result after try out.

Greetings,
Axel

Good, is this firmware for the 207 only? Let us know how you get on.

Hi Folks.

After updating the 207 with 4.40, the cam works without any problems since 4 Days.

Now i try to replace two of the 2100 by 207, because the problems with the 2100 and 1.22.2 will continue.

Because i cannot longer operate 2 systems, i must switch of the older system this week.

Two other 2100 on the 1.22.2 exist and i would be gratefull for any hints.

Thanks to the community for all the help,

Axel

I know this is an old post, however I came across a similar problem with my install, and stumbled across this thread.

I eventually found my problem. I had my 207's and the server set to auto-negotaite speed and duplex. I had everything hooked up to a netgear hub (so half duplex), and saw a _lot_ of zmc restarts from my 8 cameras. I think their could have been problems when devices re-negotiated. Swapping the hub for a switch (full duplex goodness), and my problems went away.

Might work with the hub if everything is set to half duplex, no auto-neg, but was quicker to use the switch than change each camera.

Thanks for posting this, I would never have thought of that. I thought everything was full duplex nowadays