Page 1 of 1
set record diagnostic images separately for each monitor
Posted: Sun Sep 16, 2007 1:18 pm
by hrabe
I thing, that may be very useful set option record diagnostic images separately for each monitor. When I have about 10 monitors and I would "debug" new one, I have function-less diag images from old 10 monitors...
Thanks,
M.
Posted: Sun Sep 16, 2007 8:54 pm
by jameswilson
As diag is normally used temp i think its better to waste them and have a global option. You dont leave it enabled do you? Apart from the increased load whats the problem having diag on all monitors?
Posted: Mon Sep 17, 2007 10:51 am
by hrabe
Yes, problem is the load and bandwith for bus and disk. This is the similar reason as
http://www.zoneminder.com/forums/viewtopic.php?t=9096.