ZM not capturing, until I run zmc --device 0 on cmdline
Posted: Thu Jan 22, 2004 8:40 pm
I created a monitor, and can click on it in the main window, but the image is static and does not change until I run zmc --device 0 on the cmdline, then it says 33FPS and the image updates all the time.
shouldnt ZM be able to start the capturing on its own?
maybe I did something wrong.
all else is OK though.
-Mike
shouldnt ZM be able to start the capturing on its own?
maybe I did something wrong.
all else is OK though.
-Mike