Image bleed on source change
Posted: Fri May 30, 2008 12:31 am
I have 4 Hauppauge ImpactVCBs for my older CCTV Cameras (slowly converting all of them over to Axis units). I did some cable moving so that I could load balance across the four cards so I could get better FPS (since I've been removing old CCTV cams).
Now on the units that I've changed the source I get some image bleed from a old image when doing a live view (or recording). I've tried removing power etc in case something was stuck in a buffer somewhere with no joy. I have even replaced some of the BNC cards with *NO* change.
Has anyone had this issue before? Anyone know anything I could try to fix this? (I don't want to re-OS)
Oh and I have tried completely deleting the monitor and starting over.
-Scott
Now on the units that I've changed the source I get some image bleed from a old image when doing a live view (or recording). I've tried removing power etc in case something was stuck in a buffer somewhere with no joy. I have even replaced some of the BNC cards with *NO* change.
Has anyone had this issue before? Anyone know anything I could try to fix this? (I don't want to re-OS)
Oh and I have tried completely deleting the monitor and starting over.
-Scott