ZoneMinder Forums

Hello,
I've you have an edimax IC-3010

Can you give the config for this cam

( i've one but i don't find the config )

many thanks for your help

Might give http://ip/file.jpg a try.Else maybe:

http://ip.address/snapshot.jpg
http://ip.address/snapshot.cgi

Also have a look at: http://ic1500.wikispaces.com/
Though I would have thought it to be more useful on either our wiki or Motions, but okay.

Most of this is from this thread:
http://www.zoneminder.com/forums/viewto ... x&start=15

Thanks

I've image in Web browser
( Firefox on linux no activeX )
with
http://camera-ip/snapshot.jpg

but in zoneminder it's a problem of shared memory
not the access of webcam in fact


Many thanks

i'm looking to Orbit AF Webcam configuration if anyone

Mny thanks again

Again
I've installed Zm 1.24

and want to do working my cam with this version in rtsp

i can open cam in totem
with this addresse
rtsp://192.168.0.3:554/ipcam.sdp

but i try many differents settings but i don't have any image

If someone i've found the good configuration many thanks

No suggestion of using my cam with rtsp ?

many thanks

Kerlo - or anyone else -,

do you got a solution for the rtsp stream of such camera ?

many thanks ...

Sorry i've no more news for this camera

share it on inet
and i see configuration

hi@ll,

during the last hours i've set up a new and clean lenny and installed all parts as described in the the documentation of ubuntu step-by-step. Now I have a good stream with 320x240 a average of 20-25 fps which i find very good result with zm on a virtual machine

nevertheless there are new questions:
first of all: is it possible to get a mpeg4 stream from the cam to zm ? I have tried the versions of snapshot.jpg/cgi and also the rtsp connection which all worked.
if it is so - until this time i know some commercial products which allow to do a motion detection with a stream of a low bandwidth/resolution and record a high quality stream only if a motion is detected.
with this feature (where i don't know if it possible in zm to combine to streams this way) the cpu usage could be hold very low.

so there are two questions:
1.) is it possible to receive a mpeg4 stream (cause of the firmware of the cam you can only set the resolution either for mjpeg or mpeg4 and as far as i know it is not possible to receive e.g. two mjpeg streams with different resolutions/quality at the same time) ?

2.) is it possible to do motion detection an a "low bandwidth" stream an do the record on another source with high quality ?

many thanks for your answers !

regards
stefan