Page 1 of 1
Unrecognised content type 'multipart/mixed'
Posted: Tue Apr 28, 2009 7:24 am
by cam_
Hi all,
is there a patch for zm_remote_camera.cpp available to handle those non-conform mjpeg-streams provided by some cams build by Trendnet , Micronet and others? Perhaps a proxy to convert into standard stream? Found some little hints in this forum but could not figure out if it is really possible.
Thanks for any help!
Posted: Tue Apr 28, 2009 12:04 pm
by MrEvoMan
I thought the latest idea was to upgrade the firmware of the Trendnet cameras, which resolves that problem...
I have a TrendNet IP410 and the mjpeg stream works just fine after flashing to its latest firmware.
Posted: Tue Apr 28, 2009 12:52 pm
by cam_
I own a "7Links Wireless MJPEG Network IP CAM"
http://www.pearl.de/a-PX1066-1120.shtml?query=7links
Perhaps this is the same hardware as Trendnet TV-IP201W but I'm not sure if it is possible to flash the "7Links" into a "Trendnet". But I will do further research on this, many thanks for this suggestion!!!
Greetings
cam_o
Posted: Tue Jun 23, 2009 9:46 pm
by Ryu
I believe Micronet SP5520 is the same or similar hardware/firmware like the ones you mention. Same specs, same problems etc.
http://www.micronet.info/up_images/engl ... manual.pdf
Video stream is accessible via cameraIP/goform/video like you cameras.
Shall I risk installing a Trendnet patched firmware? or I will simply kill the camera?
Micronet confirmed to me that there is no firmware upgrade from them :/