Cannot unselect Linked Monitor

SneakyPete · Post by **SneakyPete** » Mon Jun 08, 2009 12:28 pm

I selected one of my other cameras shown in the Linked Monitor section during one of my troubleshooting sessions. I didn't realize the consequences until after a few days. I have tried to unselect the camera with no success.

Does anyone know how to unselect the camera aside from deleting the camera and adding it again while being very careful not to select the other camera?

I would like to suggest an improvement to the software to alieviate this error. I suggest adding a default "none" in the list of cameras or an "enabled" or "disabled" checkbox.

Many thanks!

B00R4dL3y · Post by **B00R4dL3y** » Mon Jun 15, 2009 6:25 pm

I was able to unselect it by holding the CTRL key + clicking the mouse button.

SneakyPete · Post by **SneakyPete** » Fri Jun 26, 2009 12:19 pm

CTRL + mouse click is a solution. Thanks for the help.