zmx10 Can't Bind: Address already in use
Posted: Sat Jul 11, 2009 7:08 pm
I'm working a new install of Zoneminder 1.23.3 on Ubuntu 9.04. It is up working with my Airlink101 AIC250 camera and set to Modect.
However, I want to change it to trigger on my X10 motion sensor. I set up the x10 in the Options and trigger in the monitor General tab. From the forum discussions, I think I have it set up properly.
x10 isn't triggering any events.
Running zmx10.pl from the command line works correctly. It picks up the x10 motion detection and the event is logged in zmx10.log. It also works at the command line.
This is from my zmdc.log:
07/11/09 11:38:54.053830 zmdc[8974].INF ['zmx10.pl -c start' starting at 09/07/11 11:38:54, pid = 9761]
07/11/09 11:38:54.536701 zmdc[8974].ERR ['zmx10.pl -c start' exited abnormally, exit status 9]
This is from my zmx10.log
07/11/09 11:38:54.523217 zmx10[9761].INF [X10 server starting]
07/11/09 11:38:54.524065 zmx10[9761].FAT [Can't bind: Address already in use]
What is "exit status 9" ? What is "Can't bind: Address already in use"?
Thanks much.
However, I want to change it to trigger on my X10 motion sensor. I set up the x10 in the Options and trigger in the monitor General tab. From the forum discussions, I think I have it set up properly.
x10 isn't triggering any events.
Running zmx10.pl from the command line works correctly. It picks up the x10 motion detection and the event is logged in zmx10.log. It also works at the command line.
This is from my zmdc.log:
07/11/09 11:38:54.053830 zmdc[8974].INF ['zmx10.pl -c start' starting at 09/07/11 11:38:54, pid = 9761]
07/11/09 11:38:54.536701 zmdc[8974].ERR ['zmx10.pl -c start' exited abnormally, exit status 9]
This is from my zmx10.log
07/11/09 11:38:54.523217 zmx10[9761].INF [X10 server starting]
07/11/09 11:38:54.524065 zmx10[9761].FAT [Can't bind: Address already in use]
What is "exit status 9" ? What is "Can't bind: Address already in use"?
Thanks much.