Video recording /image capture using command line
Posted: Fri Sep 25, 2009 8:48 pm
I would be grateful if someone could point me in the right direction.
I want to be able to start this application using command line (instead of GUI) so that by issuing a command from another application or batch file, I can start and stop the capturing/ recording of video.
Is it possible? If so, please give me some advice
Is it also possible to be able to take a snapshot at certain point during the recording of the video and save that snapshot as a static image (again using command line?)
Thanks in advance.
Scot
I want to be able to start this application using command line (instead of GUI) so that by issuing a command from another application or batch file, I can start and stop the capturing/ recording of video.
Is it possible? If so, please give me some advice
Is it also possible to be able to take a snapshot at certain point during the recording of the video and save that snapshot as a static image (again using command line?)
Thanks in advance.
Scot