[ZM 1.23.3] Signal loss detection not working
Posted: Thu Nov 05, 2009 4:47 pm
Hi there!
I have got a gentoo system with 12 analog cameras attached to a pv-155p. I putted on the Config tab "SIGNAL_CHECK_POINTS=20", but when i disconnect a camera it generates a normal "Motion" event instead of a "Signal" event. I really needed zoneminder to detect loss of signals from cameras to send a notification email.
Any ideas?
Regards,
Diviner
I have got a gentoo system with 12 analog cameras attached to a pv-155p. I putted on the Config tab "SIGNAL_CHECK_POINTS=20", but when i disconnect a camera it generates a normal "Motion" event instead of a "Signal" event. I really needed zoneminder to detect loss of signals from cameras to send a notification email.
Any ideas?
Regards,
Diviner