empty events

Support and queries relating to all previous versions of ZoneMinder
Locked
freak
Posts: 112
Joined: Wed May 03, 2006 5:22 pm

empty events

Post by freak »

(edit: I just realized I posted this in the 1.24.x forum, sorry)

Using 1.23.3. I installed my 7th ip cam in to a system that is working fine. The new cam has a very nice image and is set to modect. It is set with the exact same params as the other six cams. They are all D-Link DCS-900's and this is a DCS-910. For reasons I don't understand, each time this cam captures an event it is shown as below... This exact same line shows for each event. Help!

1274241 New Event 12/18 15:10:41 0.00 / 0/0
1274237 New Event 12/18 15:08:11 0.00 / 0/0
1274231 New Event 12/18 15:07:14 0.00 / 0/0
1274230 New Event 12/18 15:04:32 0.00 / 0/0

This is in the logs...

12/18/09 14:46:36.256127 zmdc[2141].INF [Starting pending process, zma -m 13]
12/18/09 14:46:36.271782 zmdc[2141].INF ['zma -m 13' starting at 09/12/18 14:46:36, pid = 2371]
12/18/09 14:49:43.539564 zmdc[2141].ERR ['zma -m 13' exited abnormally, exit status 6]
12/18/09 14:49:43.540322 zmdc[2141].INF [Starting pending process, zma -m 13]
12/18/09 14:49:43.546269 zmdc[2141].INF ['zma -m 13' starting at 09/12/18 14:49:43, pid = 2463]
12/18/09 14:52:22.693818 zmdc[2141].ERR ['zma -m 13' exited abnormally, exit status 6]
12/18/09 14:52:22.694284 zmdc[2141].INF [Starting pending process, zma -m 13]
12/18/09 14:52:22.701662 zmdc[2141].INF ['zma -m 13' starting at 09/12/18 14:52:22, pid = 2530]
12/18/09 14:52:32.908101 zmdc[2141].ERR ['zma -m 13' exited abnormally, exit status 6]
12/18/09 14:52:37.020802 zmdc[2141].INF [Starting pending process, zma -m 13]
12/18/09 14:52:37.025305 zmdc[2141].INF ['zma -m 13' starting at 09/12/18 14:52:37, pid = 2533]
12/18/09 14:53:00.442270 zmdc[2141].ERR ['zma -m 13' exited abnormally, exit status 6]
User avatar
cordel
Posts: 5210
Joined: Fri Mar 05, 2004 4:47 pm
Location: /USA/Washington/Seattle

Post by cordel »

Try running a check on the zm database in mysql. I'm guessing that the table might have some problems. You might try enabling debug and see if it turns up any usable errors to take this from a hunch into something more usable.
Locked