PTZ control customization

[VF]

Hello,
I've buyed a ptz IP cam and I would be ale to control it.
The set of instructions are:

ptz
move ptz http://192.168.2.100/cgi.cmd?cmd=ptz&dir=left&step=1000 http://192.168.2.100/cgi.cmd?cmd=ptz&di ... &step=1000 http://192.168.2.100/cgi.cmd?cmd=ptz&dir=up&step=1000 http://192.168.2.100/cgi.cmd?cmd=ptz&dir=down&step=1000 http://192.168.2.100/cgi.cmd?cmd=ptz&dir=hroll http://192.168.2.100/cgi.cmd?cmd=ptz&dir=vroll step is the gap to move, can be from 100 to 5000,or bigger.

Could someone tell me how to configure the control tabs of ZM monitors???

Thanks!

[kingofkya]

Good place to start.

http://www.zoneminder.com/wiki/index.ph ... ra_Control

[VF]

Good place to start.

http://www.zoneminder.com/wiki/index.ph ... ra_Control

Yes...I was reading that....but still I'm not able to understand where to put the commands of my ptz cam, to map the zoneminder controls [/quote]

[curtishall]

Good place to start.

http://www.zoneminder.com/wiki/index.ph ... ra_Control

Yes...I was reading that....but still I'm not able to understand where to put the commands of my ptz cam, to map the zoneminder controls

[/quote]

http://www.zoneminder.com/forums/viewtopic.php?t=15230

That's as simple as adding six lines to a PHP file