ZoneMinder Forums

Hello,
I've buyed a ptz IP cam and I would be ale to control it.
The set of instructions are:

ptz
move ptz http://192.168.2.100/cgi.cmd?cmd=ptz&dir=left&step=1000 http://192.168.2.100/cgi.cmd?cmd=ptz&di ... &step=1000 http://192.168.2.100/cgi.cmd?cmd=ptz&dir=up&step=1000 http://192.168.2.100/cgi.cmd?cmd=ptz&dir=down&step=1000 http://192.168.2.100/cgi.cmd?cmd=ptz&dir=hroll http://192.168.2.100/cgi.cmd?cmd=ptz&dir=vroll step is the gap to move, can be from 100 to 5000,or bigger.

Could someone tell me how to configure the control tabs of ZM monitors???

Thanks!

Good place to start.

http://www.zoneminder.com/wiki/index.ph ... ra_Control

Good place to start.

http://www.zoneminder.com/wiki/index.ph ... ra_Control

Yes...I was reading that....but still I'm not able to understand where to put the commands of my ptz cam, to map the zoneminder controls [/quote]

VF wrote:

Good place to start.

http://www.zoneminder.com/wiki/index.ph ... ra_Control

Yes...I was reading that....but still I'm not able to understand where to put the commands of my ptz cam, to map the zoneminder controls

[/quote]

http://www.zoneminder.com/forums/viewtopic.php?t=15230

That's as simple as adding six lines to a PHP file