Kodicom 4400r, only able to see 2 channels
Posted: Wed Aug 04, 2010 3:51 am
Howdy,
I'm using ZM 1.24.1 under Ubuntu 9.10. The setup has 14 cameras connected and all were working previously under Windows, with this same card, before a motherboard failure. Seeing my chance I've made the new machine a linux box and implemented ZM.
I got the modprobe stuff out of the way and can now all the channels are listed in tvtime and xawtv, but I'm only able to see feeds from channel 6 and 14. I'm going back tomorrow armed with everything I can find about setting up the card, as well as tracking down the security guy so I can actually verify the cameras are still up, but I wanted to check here and see if any of you good peoples have seen a similar issue or had any thoughts.
lspci shows the video interfaces as bt878 rev 11, if that's of any importance.
Thanks!
I'm using ZM 1.24.1 under Ubuntu 9.10. The setup has 14 cameras connected and all were working previously under Windows, with this same card, before a motherboard failure. Seeing my chance I've made the new machine a linux box and implemented ZM.
I got the modprobe stuff out of the way and can now all the channels are listed in tvtime and xawtv, but I'm only able to see feeds from channel 6 and 14. I'm going back tomorrow armed with everything I can find about setting up the card, as well as tracking down the security guy so I can actually verify the cameras are still up, but I wanted to check here and see if any of you good peoples have seen a similar issue or had any thoughts.
lspci shows the video interfaces as bt878 rev 11, if that's of any importance.
Thanks!