Page 1 of 1
HOW TO -> Setup Zoneminder in a Guruplug
Posted: Wed Feb 02, 2011 10:21 pm
by PacoLM
Hi,
Find here the instructions to install the software in this tiny device!
http://plugcomputer.org/plugwiki/index.php/ZoneMinder
Hope it helps!
PacoLM
Posted: Thu Feb 03, 2011 9:16 pm
by pete_c
Very Nice PacoLM!
I've been playing with the Dockstar and have a Mimo USB Touch monitor, Keyboard and mouse connected to it.
Running a Home Automation Touch screen on it with Mono/SDL installed on a Debian base. Even TTS works just fine.
I purchased a "few" of the Dockstar's when they were on sale for $19.95. I using a second one to build a small micro 1-Wire weather station. Other folks are using it for their Asterisk server.
I'm amazed at what these little devices can do.
Posted: Thu Feb 03, 2011 10:05 pm
by PacoLM
pete_c wrote:Very Nice PacoLM!
I've been playing with the Dockstar and have a Mimo USB Touch monitor, Keyboard and mouse connected to it.
Running a Home Automation Touch screen on it with Mono/SDL installed on a Debian base. Even TTS works just fine.
I purchased a "few" of the Dockstar's when they were on sale for $19.95. I using a second one to build a small micro 1-Wire weather station. Other folks are using it for their Asterisk server.
I'm amazed at what these little devices can do.
Post the howtos in the Wiki!
Posted: Fri Feb 04, 2011 4:17 pm
by pete_c
I've never posted to the Wiki there and am not familiar with it. I didn't even know it existed. Nice Wiki.
I've been working on a kind of plug and play Dockstar Debian setup over here at this forum.
http://www.cocoontech.com/forums/
