ZoneMinder Forums

I have v1.23.3 of zoneminder and i trying to configure these IP cameras TP Link.

The cameras are working properly and transmit images directly from your IP.

In web page of zoneminder, I can't see any image.

For the TLSC-3000, i followed directions from zoneminder oficial page and configured this settings:

Remote Protocol - RTSP
Remote Method - RTSP
Remote Host Path / live/mpeg4
Remote Image Colours - 24 bit color
Capture Width (pixels) - 640
Capture Height (pixels) - 480

When i trying access the zone of the camera, image not load and get a blank image.

For TLSC-3130G is the same problem.

Has anyone resolved a similar situation? What i need to configure in zoneminder?
Can someone help?

Regards

First thing to check based on your posted settings is the "shared memory" settings. The "134217728" shmmax value is too low for 640*480. My suggestion is to double it.

http://www.zoneminder.com/wiki/index.ph ... esolutions

bb99 wrote:First thing to check based on your posted settings is the "shared memory" settings. The "134217728" shmmax value is too low for 640*480. My suggestion is to double it.

http://www.zoneminder.com/wiki/index.ph ... esolutions

Thanks for answer bb99,

I changed memory settings to double or higher but without success.​​ After restart the zoneminder, still not sending image.

Any suggestions?

Thanks

Should have caught this right off, sorry, but check to make sure that rtp/rstp isn't an option for "remote method". If it isn't then these settings are for 1.24.x. If I remember correctly rstp was fledgling in 1.23.3 (1.23.x) and there were issues.