Zoneminder on Ubuntu 11.04
Posted: Fri May 27, 2011 8:47 pm
Hello All,
I have question regarding configuration of ZM on Ubuntu. I've installed ZM, using sudo apt-get install zoneminder .. And installation went just fine.
Now, here is I wanted to do ... I have a network cam connected with my network with static IP. Following are my settings for Monitor (except default settings).
General Tab
Source Type: Remote
Function: Motion
Enabled = true
Source Tab
Remote Protocol: HTTP
Remote Method: Simple
Remote Host address: <My CAM IP>
Remote Host Port: 8005
Remote Host Path: /appro-cgi/mjpeg.cgi
In Options
Images Tab
Stream_Method: jpeg
MPEG_LIVE_FORMAT: cgi (I have no idea but I assumed it from remote host path)
Now, when I click on the Monitor ... it just shows empty white window and nothing else.
I can access Camera by typing it's IP in browser and it works just fine. But for some reason ZM can't connect to it.
Also, I tried to capture packets between my machine and Cam using Wireshark ... but I dont see any communication between them (when I run ZM, otherwise it shows data packets between them)
I have no clue where to begin from.
I will really appreciate it if anyone can guide me on it.
Thanks in advance
-Jack
I have question regarding configuration of ZM on Ubuntu. I've installed ZM, using sudo apt-get install zoneminder .. And installation went just fine.
Now, here is I wanted to do ... I have a network cam connected with my network with static IP. Following are my settings for Monitor (except default settings).
General Tab
Source Type: Remote
Function: Motion
Enabled = true
Source Tab
Remote Protocol: HTTP
Remote Method: Simple
Remote Host address: <My CAM IP>
Remote Host Port: 8005
Remote Host Path: /appro-cgi/mjpeg.cgi
In Options
Images Tab
Stream_Method: jpeg
MPEG_LIVE_FORMAT: cgi (I have no idea but I assumed it from remote host path)
Now, when I click on the Monitor ... it just shows empty white window and nothing else.
I can access Camera by typing it's IP in browser and it works just fine. But for some reason ZM can't connect to it.
Also, I tried to capture packets between my machine and Cam using Wireshark ... but I dont see any communication between them (when I run ZM, otherwise it shows data packets between them)
I have no clue where to begin from.
I will really appreciate it if anyone can guide me on it.
Thanks in advance
-Jack