Wifi Cameras and Ignoring Signal Loss Events
Posted: Wed Aug 17, 2011 5:53 pm
Is there any way to fully ignore and not create an event if signal is lost for a particular remote camera?
I have a little wireless Dlink camera overlooking my driveway. Unfortunately sometimes the signal is interrupted - it isn't very close to the rest of the house where the access point is. I haven't been able to prove it but I think often when my wife is vacuuming (good for her!), it tends to kill the connection and record events of signal loss blips of videos with blue screens in the middle. I get a lot of these events which I'm not concerned with reviewing or recording them.
BTW - I'm running v. 1.24.4
I have a little wireless Dlink camera overlooking my driveway. Unfortunately sometimes the signal is interrupted - it isn't very close to the rest of the house where the access point is. I haven't been able to prove it but I think often when my wife is vacuuming (good for her!), it tends to kill the connection and record events of signal loss blips of videos with blue screens in the middle. I get a lot of these events which I'm not concerned with reviewing or recording them.
BTW - I'm running v. 1.24.4
