ZoneMinder Forums

OS: CentOS 6 X64.

Everything seems to be good at this point but when motion is detected, the cameras go into the Alarm state.

After movement is over, or atleast that I can tell, the state still sits in Alarm.

How do I fix this?

I'd like to know too! I am using Axis cameras to do the motion detection, with ZM monitors in Nodect mode. I have seen million-frame videos captured before the alarm stops. I'd like to set a limit somewhere, but don't know where to do it.

Again, another issue fixed by another admin here. When I asked him about it, he said he messed with the frames for the alarms as well as duration. I guess its set for 600 Seconds? Ive got both our axis cameras set to Modect