Hi all.
I'm using ZM 1.24.2 with FoscamFI8908 and FoscamFI8905 models. All features work perfectly fine.
FoscamFI8908W has digital I/O connector. Which can take any digital input and provide a digital output. I was wondering if I can connect the 'relay output' of my smoke sensor to the 'alarm in' of my FoscamFI8908 model. I wish to read the relay output of the smoke sensor , so that whenever it goes active , the alarm in of my camera should sense it and zoneminder can raise an event for the same. So that I get the frames when the smoke sensor is active.
Hope it can be achieved.
Thanks.