configuring smoke sensors to raise an event
Posted: Fri Dec 23, 2011 6:44 am
Hi all.
I'm using ZM 1.24.2 with FoscamFI8908 and FoscamFI8905 models. All features work perfectly fine.
FoscamFI8908W has digital I/O connector. Which can take any digital input and provide a digital output. I was wondering if I can connect the 'relay output' of my smoke sensor to the 'alarm in' of my FoscamFI8908 model. I wish to read the relay output of the smoke sensor , so that whenever it goes active , the alarm in of my camera should sense it and zoneminder can raise an event for the same. So that I get the frames when the smoke sensor is active.
Hope it can be achieved.
Thanks.
I'm using ZM 1.24.2 with FoscamFI8908 and FoscamFI8905 models. All features work perfectly fine.
FoscamFI8908W has digital I/O connector. Which can take any digital input and provide a digital output. I was wondering if I can connect the 'relay output' of my smoke sensor to the 'alarm in' of my FoscamFI8908 model. I wish to read the relay output of the smoke sensor , so that whenever it goes active , the alarm in of my camera should sense it and zoneminder can raise an event for the same. So that I get the frames when the smoke sensor is active.
Hope it can be achieved.
Thanks.