[Solved] Foscam clone - PTZ error
Posted: Mon Jan 27, 2014 10:12 pm
Hello folks,
I can´t get PTZ functions for my foscam clones to work properly
I am using OpenSuSE 12.1 and ZoneMinder 1.26.4 and followed instructions for foscam clone owners.
When I try to make the camera go to e.g. preset 1 it does not move at all.
Several seconds later a messagebox shows the following error:
Control response was status = undefined
message = /usr/bin/zmcontrol.pl --preset=1 --command=presetGoto --id=1=>
The web ui of the camera works properly, the camera is in good condition...
I have searched all over the internet if someone got lucky to solve this problem... I didn´t find a thing.
Does anyone have an idea where to begin?
I found out that this error regarding foscam clones appears in several versions, so it would be useless installing another version?
please help
I can´t get PTZ functions for my foscam clones to work properly
I am using OpenSuSE 12.1 and ZoneMinder 1.26.4 and followed instructions for foscam clone owners.
When I try to make the camera go to e.g. preset 1 it does not move at all.
Several seconds later a messagebox shows the following error:
Control response was status = undefined
message = /usr/bin/zmcontrol.pl --preset=1 --command=presetGoto --id=1=>
The web ui of the camera works properly, the camera is in good condition...
I have searched all over the internet if someone got lucky to solve this problem... I didn´t find a thing.
Does anyone have an idea where to begin?
I found out that this error regarding foscam clones appears in several versions, so it would be useless installing another version?
please help