ZoneMinder Forums

Hello, I installed ubuntu 1.28.1 zoneminder 14.0.4 but my cam ip DLINK 932L connected to a local network is not working, I try to see more of the video stream I see all blue ... can you help me?
Thank you

Post settings and error, no one has a crystal ball here...

For a DCS-932L (I have both a DCS-932L and a DCS-930L), Monitor should be configured like this:
General -> Source Type: Remote
Source -> Remote Protocol: HTTP
Source -> Remote Method: Simple
Source -> Remote Host Name: admin:your_admin_password@your.camera.ip.address
Source -> Remote Host Port -> 80
Source -> Remote Host Path: /image/jpeg.cgi
Source -> Target Colorspace: 24 bits
Source -> Capture Width (pixels): 640
Source -> Capture Height (pixels): 480

Everything else could be left at its defaults.
Remember to setup a proper password on your camera own interface and set its resolution to 640x480 on the configuration / video section (default is a bad 320x240).
There is a rather recent firmware update for this camera (1.12.02 from 6th October 2015).
You can setup a non admin user for the camera access too if you don't want your camera's admin password to be showed inside ZM.

Regards,
Arnaud

i have a DCS-930LB1

agauthier51 wrote:For a DCS-932L (I have both a DCS-932L and a DCS-930L), Monitor should be configured like this:
General -> Source Type: Remote
Source -> Remote Protocol: HTTP
Source -> Remote Method: Simple
Source -> Remote Host Name: admin:your_admin_password@your.camera.ip.address
Source -> Remote Host Port -> 80
Source -> Remote Host Path: /image/jpeg.cgi
Source -> Target Colorspace: 24 bits
Source -> Capture Width (pixels): 640
Source -> Capture Height (pixels): 480

Everything else could be left at its defaults.
Remember to setup a proper password on your camera own interface and set its resolution to 640x480 on the configuration / video section (default is a bad 320x240).
There is a rather recent firmware update for this camera (1.12.02 from 6th October 2015).
You can setup a non admin user for the camera access too if you don't want your camera's admin password to be showed inside ZM.

Regards,
Arnaud

and it is ok for me too !!
just : Remote Host Port -> 8080

Regards,
Marco !