Floureon 720p ONVIF
Posted: Wed Jan 23, 2019 12:55 am
This is the first ip cctv I'm trying to configure for an home project (one of these you start for fun which will take not more than 1 hour to finish and then you get stacked for days 
)
I bought a Floureon ip cam and on ZN 1.32 I can configure it with no problem as monitor using the ONVIF probe.
Device name: ipcam
Device type: C9F0SeZ0N0P4L0
sw version: V13.1.6.1.26-20171207
Now I'm working on the PT (no Z) settings.
I've installed wireshark and I'm trying to figure out what information I can get out from it and I'm still lost.
Controlling the camera from http://ipcam_ip_page I can find on wireshark, if I select tcp.port == 80, all the packets exchanged between the browser and the camera. are the cgi scripts which I should be looking for? Other sort of variables?
What next?
How I tune a control file to match the camera cgi scripts or similar?
Thanks
)I bought a Floureon ip cam and on ZN 1.32 I can configure it with no problem as monitor using the ONVIF probe.
Device name: ipcam
Device type: C9F0SeZ0N0P4L0
sw version: V13.1.6.1.26-20171207
Now I'm working on the PT (no Z) settings.
I've installed wireshark and I'm trying to figure out what information I can get out from it and I'm still lost.
Controlling the camera from http://ipcam_ip_page I can find on wireshark, if I select tcp.port == 80, all the packets exchanged between the browser and the camera. are the cgi scripts which I should be looking for? Other sort of variables?
What next?
How I tune a control file to match the camera cgi scripts or similar?
Thanks