genbolt rstp:/.../11, protocol not found?
Posted: Sun Dec 13, 2020 4:52 pm
Just started trying to use zoneminder and a new camera GenBolt GB209H.
Looking at other posts setup using FFMPEG and source path rstp://name:password@ipaddress/11
with TCP.
Get logs from component zmc_m1
"Unable to open input rstp://..../11 due to: Protocol not found" file zm_ffmpeg_camera.cpp line 393
also "Failed to prime capture of initial monitor" file zmc.cpp line 257
and the console tab says "Not capturing".
I can log in to the camera on windows and see the video working.
I can log in on Linux, but the image display does not work.
This is all Greek to me. Any suggestions?
Looking at other posts setup using FFMPEG and source path rstp://name:password@ipaddress/11
with TCP.
Get logs from component zmc_m1
"Unable to open input rstp://..../11 due to: Protocol not found" file zm_ffmpeg_camera.cpp line 393
also "Failed to prime capture of initial monitor" file zmc.cpp line 257
and the console tab says "Not capturing".
I can log in to the camera on windows and see the video working.
I can log in on Linux, but the image display does not work.
This is all Greek to me. Any suggestions?