Image analysis simulation / what-if
Posted: Wed Dec 22, 2021 5:28 am
So I'm trying to tune my zone settings for better motion detection. I have some false-positive clips where motion was detected but shouldn't have been... and vice versa, where there was motion that ZM didn't flag. I know I need to adjust my zone settings but it's not always obvious which values to change to get the desired results.
If I have a clip, or even just a pair of images from successive frames, is it possible to simulate the motion detection with different inputs and preview the results? It would be great to run this offline, on a transition from one fixed image to another, and see real-time analysis frames as the parameters are adjusted.
If I have a clip, or even just a pair of images from successive frames, is it possible to simulate the motion detection with different inputs and preview the results? It would be great to run this offline, on a transition from one fixed image to another, and see real-time analysis frames as the parameters are adjusted.