Page 1 of 1
fc3 +x10 trigerring
Posted: Thu Mar 17, 2005 11:06 pm
by alexl
Hi, Cory,
can you please explain how to make x-10 trigerring
to work with your FC3 software?
Alex
Posted: Fri Mar 18, 2005 12:13 am
by cordel
Unfortunatly I do not have any X10 equipment and there fore have not had the oppertunity to play with that feature. Hopefully some one here on the forum can better advise you on how that feature works.
Cheers,
Cordel
x10
Posted: Fri Mar 18, 2005 3:35 pm
by alexl
Cory,
is x10 support included in a FC3 I got?
Alex
Posted: Fri Mar 18, 2005 4:45 pm
by zoneminder
You should be able to just set ZM_OPT_X10 in the options and then fill in the detail in the relevent options and monitor tabs (which are hidden if X10 is switched off). The README explains what all the setting mean.
Phil
x10
Posted: Fri Mar 18, 2005 6:36 pm
by alexl
Can't find tab "triggers" anywhere, though I
made x10 active in options.
Alex
Posted: Fri Mar 18, 2005 7:25 pm
by zoneminder
I don't think there is a Triggers tab, but there should be an X10 tab in the Monitors config dialog.
Phil
x10
Posted: Sun Mar 20, 2005 1:29 am
by alexl
Ok,
found X10 related dialog!
There are 3 lines:
x10 activation string
x10 input alarm string
x10 output alarm string
So, what do I put in there?
Or this is in a read me?
Best regards, Alex
Posted: Sun Mar 20, 2005 7:31 pm
by zoneminder
Yes, it's explained in the README.
Phil